多选题 Which three must be configured for the Packet Capture tool to collect all required data? ()(Choose three.)
Enter the password.
Modify the delete time to 3 hours.
Set the interface to local, remote or both.
Increase the snap length of the Packet Capture configuration.
Set the Packet Capture size to greater than the actual data flow
多选题 What are three ways to collect the diagnostics files when working with Juniper Networks Technical Assistance Center? ()(Choose three.)
Run the diag.exe CLI command.
In WebView, go to Monitor > Traffic > Export.
In WebView, go to Admin > Tools > Export Data.
In WebView, to to Monitor > Export > Export Logs.
In WebView, go to Admin > Tools > Diagnostic File.
多选题 What are two reasons why a device will fail to register to a community? ()(Choose two.)
The community name is not configured.
The registration server password is incorrect.
The registration server IP address is incorrect.
The backup registration server IP address is missing.
单选题 Which type of lock must be granted for the WX device to perform write acceleration on CIFS traffic?()
oplock
block lock
bit range lock
byte range lock
单选题 What must be enabled to view the WAN performance reports?()
Monitor > WAN > WAN Throughput
Monitor > WAN > WAN Performance
Device Setup > Applications > Monitoring
Device Setup > Advanced > WAN Performance Monitor
单选题 How do you verify connectivity between the default gateway and a WX device?()
Check the WX device remote interface and verify that the status is up.
From the WX device, ping the default gateway to make sure it is reachable.
In WebView, check the service tunnel status under Compression > Basic > Endpoints.
In WebView, check the remote routes under Compression > Advanced > Remote Routes.
多选题 Which two statements are true when source/destination filters are enabled? ()(Choose two.)
Excluded traffic is not accelerated.
Excluded traffic is only compressed.
Source/destination filter applies to all traffic sent from LAN to WAN.
Source/destination filters work in packet interception mode using RIPv2.
多选题 What are three key pre-installation/configuration considerations when deploying a WX device?() (Choose three.)
cabling
community topology
requires a license key
requires two IP addresses
registration server designation
单选题 What is one way to escape hardware bypass mode?()
Reset the cabling.
Power cycle the device.
Bounce the service tunnels.
Unlock the device from the console.
多选题 Which two configurations are made using the QoS Setup Wizard? ()(Choose two.)
Assign applications to traffic classes.
Use ToS/DSCP values for traffic classes.
Exclude subnets from QoS management.
Select dedicated vs. over-subscribed circuits.