单选题
What are the steps for configuring stateful NBAR for dynamic protocols？（）
发布日期：2020-04-13
Use the command ip nbar protocol-discovery to allow identification of stateful protocols. Use the command ip nbar port-map to attach the protocols to an interface.
Use the command match protocol rtp to allow identification of real-time audio and video traffic. Use thecommand ip nbar port-map to extend the NBAR functionality for well-known protocols to new port numbers.
Use the command match protocol to allow identification of stateful protocols. Use the command ip nbar port-map to attach the protocols to an interface.
Configure a traffic class. Configure a traffic policy. Attach the traffic policy to an interface.
Configure video streaming. Configure audio streaming. Attach the codec to an interface.
题王网让考试变得更简单
扫码关注题王，更多免费功能准备上线！
此试题出现在
CMS专题
CMS专题
其他考试
自动闭塞是根据列车运行和线路状态自动变换信号显示。
目前，麻风病微生物学诊断的主要方法是（）
1.5岁患儿，1：2000的结核菌素试验红肿硬结直径为4mm，未种卡介苗，考虑为（）
电子货币的发行成本和收益各有哪些？
下列哪种肿瘤一般不应作活组织检查（）
关于丹红用药剂量的描述正确的是（）
试述=次中修时吊主变压器器身时的检修要求？
千斤顶是一种用比较小的力就能把重物升高、降低或移动的简单机具，结构简单，使用方便，承载能力可从1t～300t，顶升高度一般为（），顶升速度可达10～35mm/min。
排水不良造成地基土扰动时，扰动深度在（）mm以内，宜填天然级配砂石或砂砾处理；扰动深度在300mm以内，但下部坚硬时，宜填卵石或块石，再用砾石填充空隙并找平表面。
慢性肾炎晚期出现大量的蛋白尿是（）
暂无相关推荐~
What are the steps for configuring stateful NBAR for dynamic protocols？（）
What are the steps for configuring stateful NBAR for dynamic protocols？ （）
Which two steps are performed when configuring a zone？（）
Which two steps are needed when configuring multiple RPs using MSDP within a sin...
Which three of the following steps are mandatory when configuring MPLS on Cisco ...
Which two steps below should you perform on the hub router while configuring EIG...
What are three necessary steps for enabling 802.1X access when configuring Layer...
Which three of the following steps are mandatory when configuring MPLS on Cisco ...
Which of these is a correct description of Stateful Switchover？（）
Which information is stored in the stateful session flow table while using a sta...