Router R1 uses S0/0 to connect via a T/1 to the Frame Relay servicE. Five PVCs terminate on the serial link. Three PVCs (101, 102, and 103) are configured on subinterface S0/0.1, and one each (104 and 105) are on S0/0 .2 and S0/0.3. The configuration shows no configuration related to EIGRP WAN bandwidth control, and the bandwidth command is not configured at all. Which of the following is true about how IOS tries to limit EIGRP's use of bandwidth on S0/0?()
Which dose the frame-relay interface-dlci command configure?()
The Frame Relay network in the diagram is not functioning properly.What is the cause of the problem?()
When configuring Frame Relay using point-to-point subinterfaces, which of the following must not be configured?()
Which Frame Relay feature is responsible for transmitting keepalives to ensure that the PVC does not shut down because of inactivity?()
Which of the following devices are protected from being motorized by a reverse-power relay?()
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()
A company has a Frame Relay WAN with one central - site router and 100 branch office routers. A partial mesh of PVCs exists: one PVC between the central site and each of the 100 branch routers. Which of the following could be true about the number of EIGRP neighbor ships?()
When should traffic shaping be implemented on Frame Relay PVCs?()
What are two characteristics of Frame Relay point-to-point subinterfaces?()