In order to configure two routers as anycast RPs, which of these requirements, at a minimum, must be satisfied?()
Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall?()
What two steps need to be taken in deploying AutoQoS for enterprise on routers?()
Routers R1 and R2, OSPF neighbors in area 0 over their Fa0/0 interfaces (respectively), currently both successfully use OSPF MD5 authentication. The OSPF configuration includes the area 0 authentication command under the router ospf 1 command. Which of the following commands must have been configur ed on R1's Fa0/0 interface?()
All secure domain routers (SDRs) have shared attributes and resources. Which three resources areshared among all SDRs? ()
Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correct BGP session endpoint addresses and the correct BGP session hop-count limit (EBGP multihop). What is a good first test to see if BGP will work across the firewall? ()
Refer to the exhibit. EIGRP has been configured on all routers in the network. What additional configuration statement should be included on router R4 to advertise a default route to its neighbors?()
Study the exhibit carefully. Routers A and B are customer routers. Routers 1, 2, 3 and 4 are provider routers. The routers areoperating with various IOS versions. Which frame mode MPLS configuration statement is true?()
Router R1 has eBGP connections to I1 and I 2, routers at the same ISP. The company that owns R1 can use public address range 130.1.16.0/20. The following output lists all the IP routes in R1's routing table within this rangE. Which of the following answers would cause R1 to advertise the 130.1.1 6.0/20 prefix to its eBGP peers?() R1# show ip route 130.1.16.0 255.255.240.0 longer - prefixes ! lines omitteD... O 130.1.16.0/24 [110/3] via 10.5.1.1, 00:14:36, FastE thernet0/1 O 130.1.17.0/24 [110/3] via 10.5.1.1, 00:14:36, FastEthernet0/1 O 130.1.18.0/24 [110/3] via 10.5.1.1, 00:14:36, FastEthernet0/1
Some of the TestKing routers have been configured with default routes. What are some of the advantages of using default routes?()