Refer to the exhibits. You are verifying your OSPF implementation, and it does not seem to be functioning properly. What can you conclude from the exhibit and the show running - configuration command output? ()
Refer to exhibits 1 and 2. In exhibit 1,all users on the LAN segment use router A as the active HSRP router. Router B is the standby router for the HSRP. In exhibit 2,the network management team reported that there is no utilization on the WAN link B. To solve this problem,you decide to change the logical topology of your LAN,but you are not sure about what changes must be made. You must manage HSRP or change it to another protocol in order to provide the most scalable design,automatic redundancy,and load balancing. Which one of these actions would be the best choice?()
View the Exhibits. You performed operations on the DEPT4 table as shown in the Exhibit. When you perform the FlashbackVersions Query, you find that the first two updates are not listed. What could be the reason?()
Refer to exhibits 1 and 2. A company uses a Metro Ethernet (Gigabit Ethernet) dedicated circuit to communicate between users (subnet B) and servers (subnet A) as shown in Exhibit 1. Both routers use OSPF to advertise the subnets. During a weekly management meeting, they realize that the WAN link is oversize. They have been using only 2 Mb/s in the worst-case scenario. So they propose a new, cheaper WAN connection using a 2-Mb/s Frame-Relay point-to-point link to interconnect both sites (Exhibit 2). The Frame Relay service provider informs them that multicast traffic is not allowed to run over the service provider network. Which one of these options is best to enable the company to establish the OSPF neighbor adjacency?()
View the Exhibits and examine lock waits. Users HR and SH complain that their transactions on one of the application tables, EMP, are waiting for response. Which action would you take to release the lock and enable users HR and SH to continue with theirtransactions()
Refer to exhibits 1 and 2. In exhibit 1, all users on the LAN segment use router A as the active HSRP router. Router B is the standby router for the HSRP. In exhibit 2, the network management team reported that there is no utilization on the WAN link B. To solve this problem, you decide to change the logical topology of your LAN, but you are not sure about what changes must be made. You must manage HSRP or change it to another protocol in order to provide the most scalable design, automatic redundancy, and load balancing. Which one of these actions would be the best choice? ()
Refer to the exhibits. Router B should advertise the network co nnected to the E0/0/0 interface to router A and block all other network advertisements. The IP routing table on router A indicates that it is not receiving this prefix from router B. What is the probable cause of the problem?()