Before replacing a MAG Series device, using the admin GUI, you export two backup files, system.cfg from "Maintenance" > "ImportfExport Configuration" and user.cfg from "Maintenance" > "Import/Export Users". When you receive the new hardware, you import all of the settings stored in the system.cfg file (including the IP address, network configuration, and device certificates), but you fail to import the user.cfg file. Which three configuration areas were updated by system.cfg?()
An administrator has just finished physically replacing the system board in a Windows domain controller. Which of the following must be done before booting the server back into Windows?()
When replacing a part with a spare one, we should fill in tile spare parts consume table in time and make a mark in brief for ()
An administrator has just finished physically replacing the system board in a Windows domain controller. Which of the following must be done before booting the server back into Windows?()
When replacing a part with a spare one, we should fill in tile spare parts consume table in time and make a mark in brief for ()
After replacing the NIC card of a PC on the LAN, your Cisco switch shows a new MAC address is attached to that port. Which of the following answer choices below correctly describe a MAC address?()
A technician is replacing a processor in a workstation. After installation, the workstation starts up and immediately shuts down; the technician tries to start the workstation several more times and gets the same result. Which of the following is the cause of this issue?()
Before replacing a piston you should check the rings to see that all clearances and gaps are within the permissible ().
Before replacing a piston you should check that all rings are ().
Before replacing a piston you should check the rings to see that all clearances and gaps are () the permissible tolerances.