The network administrator is trying to add Switch1 to the network, but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem?()
The network administrator is trying to add Switch1 to the network, but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem?()
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2?()
he network administrator is trying to add Switch1 to the network, but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem?()
hostname Switch1 interface Vlan10 ip address 172.16.10.32 255.255.255.0 no ip redirects standby 1 ip 172.16.10.110 standby 1 timers 1 5 standby 1 priority 130 hostname Switch2 interface Vlan10 ip address 172.16.10.33 255.255.255.0 no ip redirects standby 1 ip 172.16.10.110 standby 1 timers 1 5 standby 1 priority 120 HSRP was implemented and configured on two switches while scheduled network maintenance was performed. After the two switches have finished rebooting, you notice via show commands that Switch2 is the HSRP active router. Which two items are most likely the cause of Switch1 not becoming the active router? ()
The network administrator is trying to add Switch1 to the network, but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem? ()
请参见图示。网络管理员需要设置 Switch1,用于从 HostA 进行远程访问。管理员在 Ro出 show ip interface brief 命令,然后在 Switch1 上发出 show interfaces trunk 命令状态。此外,管理员还将图中所示的其它配置应用于 Switch1。但是,从 HostA 尝试 teln失败了。还需要对交换机发出哪些命令?()
请参见图示。网络管理员希望允许用户通过 SSH 和 Telnet 连接访问 Switch1。但是 SSH 连接却失败了。此问题最可能的原因是什么?()
根据下图,Switch1刚刚完成重启,并完成上电自检。HostA发送它的第一个侦到HostC,交换机首先会对switching table做什么操作()
请参见图示。Switch1 在默认的 Cisco 2960 配置基础上仅添加了如下命令: 假设网络间的路由运行正常且 Switch2 已正确配置了远程访问功能。当在 Switch1 的特权模式下输入 telnet 10.0.2.2 命令时会产生什么结果()